ACDSee Pro 6 Guia do Utilizador descarregar pdf (Página 146)

Chapter 3: Manage Mode

Special Effect

Specifies the effect you want to apply to your text. Each effect has different options that control its

appearance. Drag the sliders to adjust the appearance of the text.

Bevel Angle

Specifies the direction of the imaginary light source that creates the bevel effect. Drag the

arrow to adjust the angle - note that this also adjusts the angle of the drop shadow.

Elevation

Specifies the height of the imaginary light source that creates the bevel's shadowed

effect. Lower values produce longer shadows on the text, while a higher value produces a

more direct lighting effect and shorter shadows.

Bevel

Specifies how much of each letter's edge is beveled. Higher values give the text a more

rounded, smoother look.

Strength

Specifies the difference between the highest and lowest points on the text. Higher values

heighten the difference between the flat portions of the text and the beveled edges.

Drop Shadow Angle

Specifies the direction of the imaginary light source that creates the drop shadow. Drag

the arrow to adjust the angle—note that this also adjusts the shading of the text bevel.

Blur

Specifies the amount of blur applied to the drop shadow. Sharp shadows tend to seem

less realistic than those with a slight blur.

Opacity

Specifies the darkness of the drop shadow where it falls on the image.

Distance

Specifies the distance between the drop shadow and the text. The higher the value, the

farther the shadow and the higher the text appears.

If a drop shadow is cut off, or has a noticeably sharp edge, you may need to increase the

size of the text rectangle.

Blend Mode

Select an option from the Blend Mode drop-down list to specify how you want the text to blend into the

underlying image.

Batch Edit Watermark Options

You can use the options in the Watermark section to add a watermark to an image. You can move the watermark to any position on

the image. You can also change the opacity of the watermark and blend the watermark into the image.

To use the Watermark options:

In the Batch Edit wizard, select the Watermark check box.

Watermark options

128

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 402 403

Sem comentários

ACDSee Pro 6 Guia do Utilizador Página 146